Sterling EV Bedienungsanleitung

IIEVC-6J30-05401INSTALLER'S RESPONSIBILITYInstaller Please Note: This equipment has been tested and inspected. It has been shipped free from def

– 10 –ELECTRICAL CONNECTIONS Do not use any tools (i.e. screwdriver, pliers, etc.) across the terminals to check for power. Use a voltmeter. USE CO

– 11 –ELECTRICAL CONNECTIONS (continued)Figure 9Figure 10

– 12 – Open all disconnect switches and secure in that position before servicing unit. Failure to do so may result in personal in

– 13 –Washing the Media Avoid splashing water on the blower motor at all times (this could cause electrical problems)!1. Scale and dust s

– 14 –Roof Curb Kit - RC015* (-1, -2, -3, -4)For use with:Unit type (UT) - EVCapacities (CA) - 10/40*Evaporative Cooler Platform Only(Included with Ro

– 15 –How to order Replacement Parts Please provide the following information to your local representative: • Model Number • Serial Number (if any)

260 NORTH ELM ST., WESTFIELD, MA 01085TEL: (413) 568-9571 FAX: (413) 562-8437www.mestek.com

– 2 –RECEIVING INSTRUCTIONSInspect shipment immediately after receiving to determine if any damage has occurred during shipment If any damage is foun

– 3 –4"(102)8" CELdek®(Optional 12")2" CELdek®OverflowPumpBallValve1/4" WaterInletFloat ValveBleed-offWaterDistributionAssemb

– 4 –Rooftop Packaged Unit with Evaporative CoolingFigure 3 - Natural Vent Rooftop Unit with Evaporative Cooler (without Supply Plenum) A.G.A. C.G.A.

– 5 –Rooftop Packaged Unit with Evaporative CoolingFigure 4 - Natural Vent Rooftop Unit with Evaporative Cooler (with Supply Plenum) A.G.A. C.G.A. G

– 6 – CAPACITY A B C G ▲J 20 43-7/8" 23-13/16" 21-15/16 42-1/16" 35" (1114) (605) (557) (1068) (889) 40 60-3/8&qu

– 7 –EVAPORATIVE COOLER PARTS IDENTIFICATION161514324567891011112 9. Pump Support Bracket10. Pump11. Poly Tubing - 1/4" O.D.12. Pump Basket S

– 8 –Figure 7 - Float Valve AssemblyNOTICE: There will be a slight odor during the initial start-up of the unit. The odor will disappear within the fi

– 9 –Bleed-OffBleed-Off is required to maintain the water quality of the system. When water evaporates, minerals and other impurities are left behind,